I've just installed the appliance with VM VirtualBox, but it says missing network adapter where the IP address should be. What did I do wrong? Thanks


The "No IP address" problem is caused as the cs50 appliance expects the ip address to be on eth1. Try the following link and it should solve your probem.


  • This is the solution I usually use, but it will be undone when running update50. Feb 18 '15 at 7:45
  • This is the only working solution I've found so far. I guess you'll have to do this again after update50.
    – Ibrahim
    Feb 20 '15 at 14:36

Try this in a terminal window:

sudo service network restart

If password is asked, use Crimson


You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .